Begin with the TCP/IP Control Panel

To begin, select the apple menu from the upper left corner of the screen, and choose TCP/IP from the Control Panels sub-menu.

Configuring the TCP/IP

A) In the “Connect Via” drop-down menu choose “PPP”.
B) In the “Configure” drop-down menu choose “Using PPP Server”.
C) The next three settings (“IP Address, Subnet Mask & Router Address”) should all say “Will be supplied by server”.
D) Next, type the following numbers into the Name Server Address:
69.18.32.50
69.18.32.51

E) For the Additional Search Domains, enter:

dns1.lisco.com
dns2.lisco.com

Naming the Configuration.

Go to “File” and choose Configurations.
W hen the dialog box prompts you, click Save.

Finally, find the Active Configurations list, select Default, and select Rename. Type in Lisco, and then select OK.

Make sure that Lisco is highlighted, then select Make Active.

Go to Remote Access.

Setting up Remote Access

To manually setup the Remote Access or PPP, choose control panels from the apple menu from the upper left corner of the screen. Then click the on the words Remote Access (or PPP).

in Remote Access, Click on the Blue Triangle to the left of the word Setup to insure that the full window is shown.

Click in the circle to the left of Registered User, and then type in your username (in lowercase letters) in the name box. Type your password (in lowercase letters) in the password box.

In the Number box, type the phone number that applies to your area.

Click here for a list of access numbers.

Remote Access Options

Click on the Options button, and then click on the Protocol tab and make sure that the Use Protocol menu says PPP.

Uncheck all the boxes except for Connect Automatically When Starting TCP/IP Applications. In PPP, this option will be found in the Connection tab. Click OK.

Next , find the File menu, choose Configurations and click on Save. Then find the Active Configurations list, highlight Default, and select Rename. Type in Lisco, and then select OK.

Make sure that Lisco is highlighted, then select Make Active.